ALL SPL COMPONENTS

4 ohms Cont. Power Output (14.4V) 1375W (RMS)
2 ohms Cont. Power Output (14.4V) 2750W (RMS)
1 ohm Cont. Power Output (14.4V) 5500W (RMS)
Efficiency / Typical @ 4 ohms 90%
Min Rate @ 1 Ohm 79%
Signal To Noise Ratio >100dB
Damping Factor 200
Input Sensitivity 240mV ~ 6V
Input Impedance 20K ohms
Recommended Fuse Rating 500 Amp
Dimensions (W x H x D) mm 340 x 69 x 700
Low Pass Filter (Variable) 50 ~ 250Hz @ 24dB
Subsonic Filter (Variable) 15 ~ 50Hz @ 24dB
Frequency Response (+1 / -1 dB) 10Hz ~ 250Hz

4 ohms Cont. Power Output (14.4V) 1000W (RMS)
2 ohms Cont. Power Output (14.4V) 2000W (RMS)
1 ohm Cont. Power Output (14.4V) 3300W (RMS)
Efficiency / Typical @ 4 ohms 90%
Min Rate @ 1 Ohm 79%
Signal To Noise Ratio >95dB
Damping Factor 200
Input Sensitivity 240mV ~ 6V
Input Impedance 20K ohms
Recommended Fuse Rating 300 Amp
Dimensions (W x H x D) mm 340 x 69 x 460
Low Pass Filter (Variable) 50 ~ 250Hz @ 24dB
Subsonic Filter (Variable) 20 ~ 50Hz @ 24dB
Frequency Response (+1 / -1 dB) 10Hz ~ 250Hz

4 ohms Cont. Power Output (14.4V) 2500W (RMS)
2 ohms Cont. Power Output (14.4V) 4400W (RMS)
1 ohm Cont. Power Output (14.4V) 7000W (RMS)

S/N RATIO: 90dB at 100Hz
THD at 2 OHMS: LESS THAN 0.1%
FREQUENCY RESPONSE: 20Hz~400Hz
INPUT IMPEDANCE: 20K OHMS
INPUT VOLTAGE RANGE: 200mV~6 V
Low Voltage Protection : Under 10V
High Voltage Protection: Over 19V
FULL MOSFET 1 OHM STABLE AMPILIER
FULL PWM POWER SUPPLY
DOUBLE SIDED BLACK EPOXY PCB
HIGH QUALITY POWER & PROTECTION LEDs
THERMAL, SHORT, OVERLOAD PROTECTION
VARIABLE LOW-PASS CROSSOVER: 50~400Hz(24dB)
VARIABLE BASS BOOST: 0~18dB at 45Hz
THD at 4 OHMS: LESS THAN 0.05% at RATED POWER

Specifications
Basket Material: Aluminium coating chrome
RE: 2 ohms
QTS: 0.35
BL: 17.3
MMS: 244.1 g
FS: 40.4 Hz
VAS: 62.1 L
SPL: 91.8dB
Magnet: 440 oz
Cone: 100% Kevlar Cone
Size: 15”
RMS: 6000W

Specifications
Basket Material: Aluminium coating chrome
RE: 2 ohms
QTS: 0.48
BL: 15.4
MMS: 226.5 g
FS: 48.3 Hz
VAS: 16.1 L
SPL: 86.8dB
Magnet: 200 oz
Cone: 100% Kevlar Cone
Size: 12”
RMS: 4000W

550W RMS @ 1 OHM
325W RMS @ 2 OHM
Idle Current: 1.0 amp
Signal to Noise Ratio A-Wtd: <85dB
Total Harmonic Distortion: 0.3%
Channel Separation: N/A
Input Sensitivity: 150mV-5V
Frequency Response: <10Hz to 275Hz
Low-pass Filter: Variable 24db, 77 to 275Hz
Battery Connectors: 2 Gauge
Speaker Connectors: 8 Gauge
Slew Rate: 13V / Usec
Fuse Rating: 60 amp
Height: 2.25”
Width: 11.375”
Length: 7.375”

550W RMS @ 2 OHM
Idle Current: 1.0 amp
Signal to Noise Ratio A-Wtd: <85dB
Total Harmonic Distortion: 0.3%
Channel Separation: N/A
Input Sensitivity: 150mV-5V
Frequency Response: <10Hz to 275Hz
Low-pass Filter: Variable 24db, 77 to 275Hz
Battery Connectors: 2 Gauge
Speaker Connectors: 8 Gauge
Slew Rate: 13V / Usec
Fuse Rating: 60 amp
Height: 2.25”
Width: 11.375”
Length: 7.375”

Amplificatore SPL DYNAMICS D6 usato,riparato e perfettamente funzionante.
Amplifier SPL DYNAMICS D6 used, repaired and fully functional.

Number of channels: 1

RMS Power 1 Ohm ( 12.0V ): 4,100W
RMS Power 1 Ohm ( 14.4V ): 5,700W
RMS Power 1 Ohm ( 16.0V ): 6,700W

2pcs linked

RMS Power 2 Ohm ( 14.4V ): 11,400W
RMS Power 2 Ohm ( 16.0V ): 13,400W
THD: < 1%
Input sensitivity: 0.2 – 6 V
Lowpass filter: 20 – 200 Hz
Subsonic filter: 10 – 50 Hz
Phase control: 0 – 180 degrees
Remote level control
Two amp linkable function (Output Master/Input Slave)
2 x 1/0 Gauge power cable connectors
Line output
Dimensions ( WxHxD ): 300×68x700 mm

Per informazioni info@all-spl.com
For info info@all-spl.com